Toilet Installation in Austin, Texas: A Comprehensive Guide

If you live in Austin, Texas, you may be considering adding a new toilet to your home. Whether you are planning to replace an existing toilet or to install one in a completely new space, the process of toilet installation can be quite intimidating. With the right guidance, however, installing a toilet is not only achievable, but relatively straightforward. Here at Abacus, we specialize in plumbing and toilet installation, and the following article will provide you with a comprehensive guide to get started.

Before jumping into the installation process, there are several steps to consider first. Among the many important decisions to make is selecting the specific materials you will need for the job. Not only will this vary depending on the type of toilet you are installing, but also on the type of plumbing environment you are dealing with. Keep this in mind and hesitate to contact Abacus if you are unsure of what exactly you need for your installation.

Once you have acquired all the necessary materials, the next step in the installation process is to disconnect the existing water supply and shut off the valves. Depending on the type of shut off valve, this may require more than one person to operate it. Again, this is the kind of work that may be better left to Abacus so as to avoid any damage that may be caused by inexperienced DIY work.

Next, the old cistern must then be removed. Again, depending on the specific type of toilet, this may require one to remove the water tank from the main body, detach the soil pipe and then remove the entire unit. After this is completed, the new unit must be carefully placed in its designated spot. In order to anchor it properly and securely, bolts must be fitted, with the seals attached in between each washer and one's wall.

Once the highest point of the new cistern is secured in position, it is then necessary to connect both the soil pipe and the water inlet. The soil pipe will need to be connected to the drainage system, with the help of solvent cement, while the new water inlet must be mated with the feed pipes leading to the mains. This is an important step that requires the utmost focus as water pressure must be kept under control and monitored in order to avoid overflowing.

Once the pipes are firmly in place, it is time to connect the water supply. Depending on the specific plumbing configuration, the feed and expansion pipes must be connected, with the necessary sealings between each. It is important to keep in mind that the expansion pipe must be mounted as high as possible in order to avoid overflowing, and the cistern must be fully sealed in order to avoid any drips.

Finally, the toilet must be reconnected and tested for leaks in order to make sure that the installation was done properly and completely. As mentioned earlier, this may be best left to a professional to ensure that the job is done safely and correctly.

Toilet installation is not a task for everyone, and depending on your own particular plumbing environment, this can quickly become a challenging and complex task. Despite the complexity, seeking assistance from one of our experienced Abacus plumbers can quickly take the headaches out of the process and put your mind at ease. There is no substitute for the right knowledge and experience, and at Abacus, we are committed to delivering the best customer service experience, every time.

Topics: Toilet Installation, Plumbing, Austin TX, Abacus Plumbers